Will you be available Sat??
Motor ready to be pulled:
Headers are off:
And the truck is off the lift and she has her new shoes on, ready to be rolled
Will you be available Sat??
Motor ready to be pulled:
Headers are off:
And the truck is off the lift and she has her new shoes on, ready to be rolled
You need to get a motor plate I doubt that chain thing will work. I think the weather will be sleety and cold as hell.
You need to buy a 60K BTU heater while you are there too! They are on spring clearance. You need to build a lift plate with a 2 foot piece of 2" angle iron and an EYE bolt big enough to handle the task 7/16 or 1/2".
You need a transmission extension, deep and shallow wobble sockets, and swiveling ratchet wrenches all metric. IR 2135Ti impact, IR 2115Ti impact. A set of Husky deep impact sockets in half inch drive. All metric again.
Anything else while I'm @ the grocery store??
A good assortment of extensions and pry bars. I also like the Husky Prof 3/8 air ratchets. But the IR is probably as good Northern is an IR dealer.
wrenches
http://www.sjdiscounttools.com/kd9901.html
extension
http://www.sjdiscounttools.com/sk46175.html
reg extensions
http://www.sjdiscounttools.com/sk4538.html
shallow swivels
http://www.sjdiscounttools.com/skt33440.html
deep swivels
http://www.sjdiscounttools.com/sk33375.html
impact sockets, Husky is cheaper $65.
http://www.sjdiscounttools.com/sk4048.html
impact 1/2
http://www.sjdiscounttools.com/ir2135qti.html
impact 3/8
http://www.sjdiscounttools.com/ir2115ti.html
pry bars
http://www.sjdiscounttools.com/skt6093.html
Just ordered all of the tools that you listed
Will be going by Northern later today to get the rest
Hey Bic, I still have that empty 55-gal barrel if you want it. Terry are you still in the same apartment? Maybe we can meet at convenient location and you can take it to Bic?
I'm still here but I don't carry barrels in my Lightning
Anything els Terry???
New Heater:
Tranny Jack
Why do you want to pull the tranny? I said 60K heater that is 35K! Are the tools going to be here in time? If not I am making other plans.
There are currently 1 users browsing this thread. (0 members and 1 guests)