PDA

View Full Version : uh oh, wobley pulley



microsuck
03-03-2003, 10:32 PM
Terry,
i cut that 99 4# pulley to fit my 01. it is a pretty good fit ( but not perfect) the 3 bolts do line up correctly thought. when I use it, it wobbles a bit. I think it will wear on the crank or something. whats your verdict? fine or dangerous?
Andrew

L8 APEX
03-04-2003, 12:17 AM
Does it wobble in and out or up and down:D Some pulleys have a touch of runout like thousandths. The key is that the load is centered on the hub and bolts just hold it in place.

microsuck
03-04-2003, 12:48 AM
I guess I will have to go look more closely.:twitch: It bolts fine, but I dont remember the stock one shaking. The load is on the hub, cause it was hard to get on there, and since the bolts line up I would assume it is even.
Andrew

cpeapea
03-04-2003, 11:30 AM
it didnt look like it was shaking that much, i think it was going up and down, i was also looking at the tensioner to see if it was affected and it didnt seem to wobble more than with the stock pulley