PDA

View Full Version : Vehicle after Lightning?



Chris94L
05-03-2010, 09:01 PM
Seems like it has been forever since I have been on this site. How is everyone doing? Here is the new Hot Rod...

http://i230.photobucket.com/albums/ee135/Chris94L/d3d143b5.jpg

http://i230.photobucket.com/albums/ee135/Chris94L/2935d2b7.jpg

mustgofaster
05-03-2010, 09:05 PM
I like! So when & where do I show up for my ride?

Chris94L
05-03-2010, 09:13 PM
We are usually on Lavon. This is from yesterday. 9 jets were out there.

http://i882.photobucket.com/albums/ac26/OhOneWS6/Lavon%2005-01-10/DSCF1458.jpg

Run 63 on GPS yesterday got it back to the house found out it was only firing on 6 holes. Put a FP gauge on it and found out it was only running 5.5psi to the carbs. He ran it way lean and burnt up 2 electrodes on the plugs. I'm hoping/expecting mid 70's out of it with the motor tuned right then I will start tweaking the ride plates on the hull. Too wet right now need to get it up out of the water some more.

dboat
05-03-2010, 09:17 PM
any luck catching fish out of her? ;)

Dana

Ohmsby
05-03-2010, 09:31 PM
it looks faster than 70.....:rolleyes:

Chris94L
05-03-2010, 09:41 PM
Well duh, why do you think its tied up instead of out running around ;)

Moonshine
05-04-2010, 08:31 PM
Sweet lookin' ride. :tu: Boats always look faster than they are, especially jets. But they sure do look and sound cool.

Chris94L
05-17-2010, 05:33 PM
Was trying to locate reason behind excess crankcase pressure and low speed. Pulled plugs and found 2 of the electrodes consumed. Ran compression test and found same 2 cylinders were at about 30psi with the rest between 160-170psi. Both of those holes had the headgasket blown out into the lifter valleys. Guy changed the FP regulator on it and didn't put a gauge so I have to assume the pressure was way too low causing it to lean out and blow. Switching from the tunnel ram and dual 4's for a little simpler setup Dart intake with a Dominator 1050. Will find a dragster scoop and paint it probably the same color purple that is on the rest of the boat. Should be a runner when its back together hoping for around 500-550hp, and might go ahead and add a little 'mo just in case but that will be a ways down the road. My friend was pissed as hell at the guy I bought it from but really what are you gonna do? One of the joys of buying someone else's project/Hot Rod